DecoFilm® Soft Metallic Purple HTV - CraftCutterSupply.com

DecoFilm® Soft Metallic Purple HTV

2 Reviews
| Ask a question


Add perceived value to your fashion designs with the brilliant accent of precious metals. Offers a smooth and soft metallic finish. It is stretchy, very durable, and comes in many different finishes and patterns. It offers a soft hand and when applied, will take on the texture of the garment.

 

Application Instructions

Applies to: Cotton, Uncoated Polyester, Fabric Blends, Polyester/Acrylic, and Similar Fabrics (Not suitable for treated or dyed garments) Excluding Nylon

We do not recommend this product as a bottom layer.

Blade – 45°

Cut – Mirror image

Temp – 302°-320° F

Pressure – Firm, even

Time – 7-8 seconds

Peel – COLD, then cover with Teflon and repress for 3-5 seconds

Care – Wash inside out, cold water, gentle cycle. Tumble dry low.

Tech Info

 

Special Precautions:

AFTER WASHING, ALWAYS IRON INSIDE OUT - DO NOT IRON DIRECTLY ON THE FILM. CANNOT BE USED AS A BOTTOM LAYER!

Please note: The white is translucent. The following colors are translucent in some areas and any color garment will show through: Green/Black Camo, Earthtone Camo, Grey Camo, and Blue/Black Camo. The following colors are slightly translucent, but does not appear to show color through when pressed: Rainbow Oil, Leopard Silver, and Leopard Gold.

Size is +/- 0.50inch

*Colors of products may be different than what the screen on your device shows.

TIP: Always perform a test cut prior to cutting a whole design

*The carrier sheet of the vinyl may show scratches. This will not affect the vinyl in any way. It will be removed and thrown away after the material is applied to a garment. There will not be any returns, exchanges or refunds for the carrier sheet being scratched. Helpful tip-Specialty Materials recommends if your T shirt or material your are putting this HTV on says "dry fit", "Moisture Wicking", or is Gildan Ultra Cotton, use a spray bottle of rubbing alcohol and squirt the material where you are putting the design. Then rub it in a bit with a cloth and dry or even heat press it to dry then press the design. This is due to the material being a coated material, instead of an un coated material.

We Also Recommend