Get A FREEBIE With Your Order Placed Today!!!

Cart (0)

Subli-Print® Light 5 Pack (For A Sublimation Printer)

1 Review
| Ask a question

Sale price $17.69 Regular price $20.86

This 5 pack comes with 5 printable sheets AND 5 transfer mask sheets.

Sheet size is 8 7/8 x 11.

Application Instructions

1. Insert your Subli-Print® Light sheets into your printer- shiny side up.

2. Print in “right reading” directly onto the Subli-Print® Light using your sublimation printer. Please note: Colors will look dull prior to pressing.

3. Allow the vinyl to dry prior to pressing- either under a hot heat press plate for 1 minute or by air drying for 30 minutes.

4. Cut using a 45° Blade and weed the excess material.

5. For solid designs, no mask needed- simply peel design away from carrier, lay on garment, apply cover sheet and press. For multi-piece or more intricate designs, use Subli-Mask or a silicone based mask, such as HFIX-SIL, to transfer the image. Remove the backing from the mask, apply it to the printed image, then use a squeegee to smooth the mask down.

6. Remove the backing, leaving only your masked design.

7. Pre-heat garment for 2-3 seconds.

8. Place the masked design onto the garment.

9. Cover with a transfer sheet and apply using the settings below:

Medium, even pressure

15 Seconds

Wait 24 hours before first wash. Wash inside-out with mild detergent, gentle cycle, cold water, tumble dry. No bleach or other harsh cleaners.

Not suitable for dry-cleaning.

PEEL 311°F

Peel Warm

Suitable for light and dark colored cotton, polyester, or cotton/poly blended garments 

Application Instructions

Transfer Material – If needed, use SubliMask or silicone-based mask such as HFIX-SIL

Temp – 311° F

Pressure – Medium, even
Time – 15 seconds

Peel – Warm

Care – Wait 24 hrs before first wash. Wash inside out with mild detergent, gentle cycle, cold water, tumble dry. No bleach or other harsh cleaners. Not suitable for dry-cleaning.

Applies to: Cotton, Uncoated Polyester, Cotton/Polyester Blends Excluding Sublimated Polyester

Basic Cutter Settings Settings may vary depending on machine and blade condition.

Use these settings as a base point. Always do a test cut prior to cutting your design!

Silhouette Blade: Auto, 3 Material: Heat Transfer Flocked Speed: 8 Force: 15

Roland Blade: 45° Blade Gram Force: 110-120 Speed: 30 cm/s

Graphtec Blade: 45° Blade Gram Force: 10-12 Speed: 30 cm/s

Cricut Blade: Standard Setting: Iron-on

Size is +/- .5 inch on width, 3% on Length

Colors of products may be different than what the screen on your device shows. TIP: Always perform a test cut prior to cutting a whole design.

No Refunds